NASG Dispatch Articles by John Long
'S' Lore
Issue:
1990 #6 December
Page:
9
Category:
Tools
Description:
Using superglue.
Installing Onboard Command Control in S Gauge Part III
Issue:
1991 #4 August
Page:
6
Category:
Electronics
Description:
The author describes how he installed command control into an American Model FP7.
Installing Onboard Command Control in S Gauge Part VI
Issue:
1994 #5 October
Page:
30
Category:
Electronics
Description:
This installment covers installing the Keller Engineering system into an American Models GP, which proved to be difficult due to the lack of interior space.
Installing Onboard Command Control in S Gauge Part VII
Issue:
1995 #1 February
Page:
8
Category:
Electronics
Description:
This installment covers how to provide flicker-free lighting. Several engine installations are covered in the article.
Installing Onboard Command Control in S Gauge Part VIII
Issue:
1995 #2 April
Page:
17
Category:
Electronics
Description:
More about the flicker-free circuitry introduced in the previous issue, specifically covering the Rex engines.
Installing Onboard Command Control in S Scale Part IV, V
Issue:
1992 #2 April
Page:
10
Category:
Electronics
Description:
The article starts off with a preface by the editor Bob Jackson, correcting a number of mistakes in his previous introductory article on command control in the February 1992 issue. The series continues with a description of install the Onboard system in Omnicon F7 A and B units, and in an American Model GP9.